![]() ![]() The rollers may have something to do with it, but the dull knives have a bigger affect on this.Ĭlick here for instructions for getting a replacement product manual. Even if the knives are new or have only had a couple board feed ran through them, still flip all the knives anyways and see if that improves the process. /rebates/2fp2fPOWERTEC-12-1-2-in-High-Speed-Steel-Planer-Knives-for-DEWALT-DW733-Set-of-2-1280902f300082256&. What should be done is change or reverse all the knives. When the cutterhead is lowered and the knives engage the board that is when the board sometimes doesn't feed. We want to check the knives first, because even if the cutterhead is too high and the knives don't engage the board the rollers are still rolling and the board will feed in. Check all adjustments as per the instruction manual. ![]() Clean feed and table rollers Clean and wax the bed using warm soapy water, dry and apply a good paste type floor wax (like Johnson's Floor Wax) Adjust table and feed rollers as described in your owners manual. Check all adjustments as per the instruction manual. Follow Perform the following: Reverse or replace the knives.Adjust table and feed rollers as described in your owners manual.Clean and wax the bed using warm soapy water, dry and apply a good paste type floor wax (like Johnson's Floor Wax). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |